[f-nsp] Problem with adding new 1G link to static LAG

[Robert Hass]

Hi

I have problem with adding new 1Gb link to existing 3x1Gb LAG (trunk).
Switch don't want to
accept below command:

BR-telnet at sw03(config)#trunk ethe 0/1/21 to 0/1/24
Error - Trunk/Port does not match: Port 0/1/21 -> Trunk Id 21 But Port
0/1/24 -> Trunk Id 2049

Is any solution to my problem ?

My configuration:

Ports 0/1/21 to 0/1/23 - ports currently active in LAG
Port 0/1/24 - new port which I would like to add to above LAG

Config file:

trunk ethe 0/1/21 to 0/1/24
!
interface ethernet 0/1/21
 port-name r01
 load-interval 30
 spanning-tree 802-1w admin-pt2pt-mac
 no flow-control
 pvst-mode
!

Output of 'show trunk' command:

>Configured trunks:

[...]

Trunk ID: 21
Hw Trunk ID: 2
Ports_Configured: 3
Primary Port Monitored: Jointly

Ports         0/1/21  0/1/22  0/1/23
Port Names    none    none    none
Port_Status   enable  enable  enable
Monitor       off     off     off
Rx Mirr Port  N/A     N/A     N/A
Tx Mirr Port  N/A     N/A     N/A
Monitor Dir   N/A     N/A     N/A

>Operational trunks:

[...]

Trunk ID: 21
Hw Trunk ID: 2
Duplex: Full
Speed: 1G
Tag: Yes
Priority: level0
Active Ports: 3

Ports         0/1/21  0/1/22  0/1/23
Link_Status   active  active  active
port_state    Forward Forward Forward

Software/hardware:

  Copyright (c) 1996-2010 Brocade Communications Systems, Inc.
    UNIT 1: compiled on Feb 16 2011 at 05:19:32 labeled as FGSL07202a
                (3165658 bytes) from Primary FGSL07202a.bin
        SW: Version 07.2.02aT7e1
  Boot-Monitor Image size = 416213, Version:05.0.00T7e5 (Fev2)
  HW: Stackable FLS624

-- 
Thanks,
Robert