[f-nsp] Rate limiting UDP traffic on MLXe

[Chris Hellkvist]

Hi all,

i'm trying to set up a rate limiting for all UDP traffic on a VE
interface on a MLXe using Ironware 5.3.0b. The VE interface is only
used on a physical port/the VLAN is only configured on a single port -
but there are some other vlans also using the same port so i can't
move the interface to a route-only config that easy.
It looks like it is not possible to set up a ACL based rate limit on a
VE interface. Instead using a VLAN-based rate limit it seems that it
is not possible to use this together with a ACL for matching only UDP
traffic.

Any ideas/workarounds for this case?

Thanks,
-chris