[f-nsp] NI-MLX-1Gx48-T 48-port 10/100/1000Base-T MRJ21 Module **" INCOMPATIBLE_MAXIFINDEX_CONFIG"**

[Carlos Alfaro]

 I have a issue with NI-MLX-1Gx48-T  MRJ21 module just boot into the interactive mode.

The module is installed on MLX-8 Chassis. running code version 5.6.0aT163

 I have 2 management modules  and 2 High Speed Fabric switch. 

2 X  NI-MLX-MR
2 x  SFM NI-X-HSF
2 x 1200 watts  Power supply.

The module boot on to the interactive mode with the error message " INCOMPATIBLE_MAXIFINDEX_CONFIG"

did I missed something in the configuration 

any help will be appreciate. 

Thanks

***************************************************************************************************


NetIron MLX-8 Router#show ver
System Mode: MLX
Chassis: NetIron 8-slot (Serial #: A60532F06T,  Part #: 35549-000C)
NI-X-HSF Switch Fabric Module 2 (Serial #: BEU0329F07S,  Part #: 60-1001588-12)
FE 1: Type fe600,  Version 1
FE 3: Type fe600,  Version 1
Switch Fabric Module 2 Up Time is 2 minutes 54 seconds
NI-X-HSF Switch Fabric Module 3 (Serial #: BEU0316F0ED,  Part #: 60-1001588-08)
FE 1: Type fe600,  Version 1
FE 3: Type fe600,  Version 1
Switch Fabric Module 3 Up Time is 2 minutes 54 seconds
==========================================================================
SL M1: NI-MLX-MR Management Module Active (Serial #: S10526F06N, Part #:    35524-103J):
Boot     : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:42:38 labeled as xmprm05600
 (516258 bytes) from boot flash
Monitor  : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:41:56 labeled as xmb05600
 (534157 bytes) from code flash
IronWare : Version 5.6.0aT163 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Dec  5 2013 at 11:00:34 labeled as xmr05600a
 (9154849 bytes) from Primary
Board ID : 00 MBRIDGE Revision : 37
916 MHz Power PC processor 7447A (version 8003/0101) 166 MHz bus
512 KB Boot Flash (AM29LV040B), 32 MB Code Flash (MT28F128J3)
1024 MB DRAM INSTALLED
1024 MB DRAM ADDRESSABLE
Active Management uptime is 2 minutes 54 seconds
==========================================================================
SL M2: NI-MLX-MR Management Module Standby (Serial #: N02626F09D, Part #:    35524-103K):
Boot     : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:42:38 labeled as xmprm05600
 (516258 bytes) from boot flash
Monitor  : Version 5.6.0T165 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Sep 20 2013 at 16:41:56 labeled as xmb05600
 (534157 bytes) from code flash
IronWare : Version 5.6.0aT163 Copyright (c) 1996-2013 Brocade Communications Systems, Inc.
Compiled on Dec  5 2013 at 11:00:34 labeled as xmr05600a
 (9154849 bytes) from Primary
Board ID : 00 MBRIDGE Revision : 37
916 MHz Power PC processor 7447A (version 8003/0101) 166 MHz bus
512 KB Boot Flash (MX29LV040C), 32 MB Code Flash (MT28F128J3)
1024 MB DRAM INSTALLED
1024 MB DRAM ADDRESSABLE
Standby Management uptime is 2 minutes 15 seconds
NetIron MLX-8 Router# show mod
Module                                                      Status                       Ports    Starting MAC
M1 (left ):NI-MLX-MR Management Module                      Active              
M2 (right):NI-MLX-MR Management Module                      Standby(Ready State)
F1:
F2: NI-X-HSF Switch Fabric Module                           Active              
F3: NI-X-HSF Switch Fabric Module                           Active              
S1:
S2:
S3:
S4:
S5:
S6:
S7:
S8: NI-MLX-1Gx48-T 48-port 10/100/1000Base-T MRJ21 Module   CARD_STATE_INTERACTIVE (INCOMPATIBLE_MAXIFINDEX_CONFIG)
(S8: Configured as invalid module)
NetIron MLX-8 Router#show log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
    Buffer logging: level ACDMEINW, 18 messages logged
    level code: A=alert C=critical D=debugging M=emergency E=error
                I=informational N=notification W=warning

Static Log Buffer:
Feb 11 00:45:11:A:System: AC Power Supply 1 , 1st from left, Installed (OK)
Feb 11 00:45:11:A:System: AC Power Supply 2 , 2nd from left, Installed (OK)
Feb 11 00:45:11:A:System: Power Supply 3 , 3rd from left, Installed (Failed or Disconnected)
Feb 11 00:45:16:I:System: i2c access notice (GIEI = set)Minor, Mux index 0, Mux tap 5, ID 0x1, Addr 0x6, (PS3)
Feb 11 00:45:16:I:System: last good i2c access, Mux index 0, Mux tap 5, ID 0x1, Addr 0x5, (PS2)

Dynamic Log Buffer (500 lines):
Feb 11 00:46:26:N:Module 8 is reset by mgmt (reason: boot to interactive mode)
Feb 11 00:46:07:N:Module 8 is reset by mgmt (reason: CLI command)
Feb 11 00:45:38:N:System: Standby Management Module was ready
Feb 11 00:45:28:N:Module 8 is reset by mgmt (reason: boot to interactive mode)
Feb 11 00:45:23:I:System: Interface ethernet mgmt1, state up
Feb 11 00:45:16:I:System: last good i2c access, Mux index 0, Mux tap 5, ID 0x1, Addr 0x5, (PS2)
Feb 11 00:45:16:I:System: i2c access notice (GIEI = set)Minor, Mux index 0, Mux tap 5, ID 0x1, Addr 0x6, (PS3)
Feb 11 00:45:11:I:System: Warm start
Feb 11 00:45:11:A:System: Power Supply 3 , 3rd from left, Installed (Failed or Disconnected)
Feb 11 00:45:11:A:System: AC Power Supply 2 , 2nd from left, Installed (OK)
Feb 11 00:45:11:A:System: AC Power Supply 1 , 1st from left, Installed (OK)
Feb 11 00:45:09:I:Power Supply 4  is Not Installed (FAILED)
Feb 11 00:45:09:A:System: Power Supply 3 , 3rd from left, Installed (Failed or Disconnected)
Feb 11 00:45:09:I:Power Supply 3  is Installed (Failed or Disconnected)
Feb 11 00:45:09:A:System: AC Power Supply 2 , 2nd from left, Installed (OK)
Feb 11 00:45:09:I:AC Power Supply 2  is Installed (OK)
Feb 11 00:45:09:A:System: AC Power Supply 1 , 1st from left, Installed (OK)
Feb 11 00:45:09:I:AC Power Supply 1  is Installed (OK)
NetIron MLX-8 Router#^C
NetIron MLX-8 Router#

*****************************************************************************************************************


Carlos Alfaro  Tech / Sales Support

Townsend Networks

35 Reed Blvd., Suite A  Mill Valley, CA 94941                    

415-384-4208 

mailto:carlos at townsendnetworks.com