[f-nsp] How to see the make and model of a transceiver

[Nick Cutting]

Thank you

-----Original Message-----
From: Jonas Frey (Probe Networks) [mailto:jf at probe-networks.de] 
Sent: 23 March 2016 14:27
To: Nick Cutting
Cc: foundry-nsp at puck.nether.net
Subject: Re: [f-nsp] How to see the make and model of a transceiver

Hello Nick,

you can do this via the hidden "dm" command:

dm optic x/x/x eeprom

This will show the eeprom contents of the transceiver (S/N, manufacturer etc).

-Jonas


Am Mittwoch, den 23.03.2016, 14:16 +0000 schrieb Nick Cutting:
> This is on a brocade ICX6610
> 
>  
> 
> Is there a brocade equivalent of the cisco command show interface x/y 
> capabilities ?
> 
>  
> 
> The show interface command gives me the below:
> 
>  
> 
> SSH at ETGUKHEXSAN02#sh interfaces e 1/3/1
> 
> 10GigabitEthernet1/3/1 is up, line protocol is up
> 
>   Port up for 18 days 19 hours 23 minutes 23 seconds
> 
>   Hardware is 10GigabitEthernet, address is cc4e.24c2.efa0 (bia
> cc4e.24c2.efc3)
> 
>   Interface type is 10Gig SFP+ Copper
> 
>   Configured speed 10Gbit, actual 10Gbit, configured duplex fdx, 
> actual fdx
> 
>  
> 
> So I know it’s a twinax cable (SFP+ copper – and I plugged it in)– but 
> I was hoping to get more information ?
> 
> 
> Any ideas?
> 
> 
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp