[f-nsp] Brocade XMR / Juniper iBGP Interoperability

Jody Botham jody at ask4.com
Wed Nov 16 12:25:43 EST 2016


Are you doing any hair-pinning of traffic on the XMR in/out a VLAN on the
same physical interface? NetIron generates an ICMP redirect by default in
this situation which with lots of traffic can kill the lp. Check if you've
disabled icmp redirects.

On Wed, 16 Nov 2016 at 17:15, Daniel Stephens <ds-lists at ndnx.net> wrote:

I will need to capture the debug data when attempting to bring the session
back up, but since these two networks are production, I am limited in the
time frames I can do so due to it becoming service affecting when the
sessions all drop.

I do not have the exact output of “show cpu lp X”, but graphs I have of the
processor on the management module and line cards show both going up to
roughly 80-90% during the event.

Thanks,
Daniel

On 11/16/16, 12:10 PM, "Ryan Harden" <hardenrm at uchicago.edu> wrote:

    What does ‘show cpu lp X’ say during the error/failure state?

    /Ryan

    Ryan Harden
    Research and Advanced Networking Architect
    University of Chicago - ASN160
    P: 773.834.5441




    > On Nov 16, 2016, at 10:52 AM, Daniel Stephens <ds-lists at ndnx.net>
wrote:
    >
    > Hi Jörg,
    >
    > The line card does not reset. Under show logging during the event,
the only thing are OSPF neighbor changes when they drop and reestablish.
    >
    > SSH at xmr01#sh ip bgp nei $MX_IP last-packet-with-error decode
    > No received packet with error logged for neighbor $MX_IP
    > SSH at xmr01#
    >
    > On the upstream carrier BGP neighbor, when it reset, the XMR reported
the following –
    >
    > Notification Sent:     Hold Timer Expired
    > Notification Received: Cease/Connection Rejected
    >
    > Thanks,
    > Daniel
    >
    >
    > From: Jörg Kost <jk at ip-clear.de>
    > Date: Wednesday, November 16, 2016 at 11:41 AM
    > To: Daniel Stephens <ds-lists at ndnx.net>
    > Cc: "foundry-nsp at puck.nether.net" <foundry-nsp at puck.nether.net>
    > Subject: Re: [f-nsp] Brocade XMR / Juniper iBGP Interoperability
    >
    > Hi,
    > does the line card reset?
    > Also any output from
    > show logging
    > or bgp, e.g.
    > sh ip bgp neighbors $neighbor last-packet-with-error decode
    > may be helpful.
    > Jörg
    > On 16 Nov 2016, at 17:10, Daniel Stephens wrote:
    > Hi everyone,
    >
    > I am having a strange issue with our Brocade XMRs when I attempt to
exchange routes between a new set of Juniper MX iBGP peers and was looking
to see if anyone had any recommendations.
    >
    > The Brocade XMRs have two line cards, a 20-port 1G and a 4-port 10G
card installed, and are running 5.6.0d firmware.
    >
    > We are integrating two existing networks as a consolidation, with the
one network running Brocade XMR and the other running Juniper MX routers.
The issue surfaced on the XMRs when we removed route filters on the iBGP
sessions between the XMR and MX routers. When lifting the filters and
sending routes from the XMR towards the MX, everything is functioning as
normal and the MX correctly learn the routes. Our issue becomes when we
lift the filter and send routes from the MX towards the XMR. The XMR begins
to load the routes correctly, and at some point during this process, the
XMR stops forwarding traffic on the 4-port 10G line card entirely (the card
to which the MX routers interconnect), and all BGP sessions associated with
that line card flap, and OSPF adjacencies drop and re-establish.
    >
    > I am using the ipv4-ipv6-2 CAM partition profile on the XMR devices.
Total number of routes attempting to be passed is a full table of roughly
610K routes.
    >
    > Even when I remove an XMR unit from service and attempt to load
routes from the MX into the XMR, the same anomaly occurs.
    >
    > Any assistance would be greatly appreciated.
    >
    > Thanks,
    > Daniel
    > _______________________________________________
    > foundry-nsp mailing list
    > foundry-nsp at puck.nether.net
    > http://puck.nether.net/mailman/listinfo/foundry-nsp
    > Jörg Kost
    > Hofmeir Media GmbH
    > Kranzhornstr. 3
    > 81825 München
    > Tel: 089/48002910
    > Fax: 089/4487505
    > jk at hofmeirmedia.net
    > https://www.premium-datacenter.de
    > https://www.xing.com/profile/Joerg_Kost
    > Geschäftsführer: Dipl.-Ing. (Univ.) Stefan Hofmeir
    > Handelsregister AG München: HRB 130092
    > _______________________________________________
    > foundry-nsp mailing list
    > foundry-nsp at puck.nether.net
    > http://puck.nether.net/mailman/listinfo/foundry-nsp



_______________________________________________
foundry-nsp mailing list
foundry-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/foundry-nsp
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20161116/cd49a27a/attachment-0001.html>


More information about the foundry-nsp mailing list