[f-nsp] FIB Filter

[i3D.net - Martijn Schmidt]

Hi Rob,

You can only do selective programming on NetIron when you use a VRF with less routes on the -M card. But if you have -X cards (and not -X2) you've probably already selected a cam-partition profile without vrf support to make sure you could still fit a full table into FIB. Hence, no can do. 

Best regards,
Martijn 

On 12 September 2018 00:57:21 CEST, Robert Hass <robhass at gmail.com> wrote:
>Hi
>Is any command which I can use to filter routes installed in FIB ? As I
>can
>do that on IOS or JunOS...
>
>I need to install -M linecard for connect few new servers and mix it
>with
>existing -X linecards. On this machine I have full-bgp-feed. So I need
>to
>filter some specifics prefixes.
>
>I'm running NI 6.2 on MLXe-4, but can upgrade to 6.3 if it's required.
>
>Rob

-- 
Sent from my Android device with K-9 Mail. Please excuse my brevity.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20180912/4b524a7d/attachment.html>