<div dir="ltr"><br><div>I'm setting up a backup tunnel across the Internet to connect two sites and want to dual-stack ipv4+ipv6.</div><div><br></div><div>I've built a GRE tunnel and configured IPv4 on it, works fine.  </div><div><br></div><div>But, when adding ipv6 addr on GRE tunnel, I get:</div><div>  "Error - IPv6 address can be configured ONLY on IPv6 tunnels"</div><div><br></div><div>Ok, so I'll try to add a separate IPv6 tunnel:</div><div><br></div><div><div>SSH@XMR(config)#int tunnel 2</div><div>SSH@XMR(config-tnif-2)#tunnel mode ipv6ip</div><div>SSH@XMR(config-tnif-2)# tunnel source x.y.z.38                                        </div><div>SSH@XMR(config-tnif-2)# tunnel destination x.y.z.186  </div><div>Error - Tunnel src and dest not unique, match that of Tunnel 1</div><div><br></div></div><div>Unfortunately I don't have extra IPv4 source and dest IPs that I can burn up.</div><div><br></div><div>This is an XMR box running NI 5.5.</div><div><br></div><div>Cisco and Juniper both support IPv4+IPv6 on top of GRE, has Brocade implemented this in a newer release?</div><div><br></div><div>I also tried to do IPv6 tunnel on top of IPv6, but that doesn't seem to be available either.  Is there something I've missed?</div><div><br></div><div><br></div><div>Mark</div><div><br></div><div><br></div><div><br></div></div>