Looking for Nylon Spiral follower for SB-110

[Nick England]

Don't know of a source, but it is common for this little pin to
break off. I have one rig where this was repaired by replacing it with
a small steel pin - either glued into a hole or more likely, heated
and pushed into place. Seems liek this should work OK with a dab
of silicone grease to keep things sliding along.

73 & Have Fun,
Nick England  KD4CPL  nick at cs.unc.edu   Univ. Of North Carolina
http://www.cs.unc.edu/~nick             Chapel Hill NC

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --