HW-101

[Sean Pratt]

Greenies

Here's an interesting problem..   Actually, this is an ongoing saga,
regarding low audio output on LSB and even lower on USB and CW.

If I ever so gently tap ANYWHERE on the HW with the plastic end of a
screwdriver.  the audio level changes and the Cal signal changes pitch
or dissappears completely.  Tap again and reappears.  When I say tap, I
mean  REALLY LIGHTLY, especially around the VFO enclosure, or Crystal
filter.  I'm assuming this isn't normal.  But then, you know what they
say about assume.

Also, I can not not increase the Het oscillator voltage from -0.34 to
what is called for in the manual..  (-0.5 to -2) on 28 and 29.5.  I
replaced the Het board Het Oscillator thinking that is was the coils.
Well, after replacing that board I still cannot adjust the voltages on
those 2 bands.

Any ideas?

73

Sean

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --