ALC meter reading on HW-100 and SB-102

[Allen, KJ6XH]

Hi Greenies!

Problem: ALC reads below Zero on SSB transmit and low on
voice peaks.

Heath Tech Bulletin HW-100-18 addresses this problem for
the HW-100 and says: "add a 2K ohm resistor or 10K trim
control between lug 1 of relay 1 and the center lug of the
S-meter zero-adjust control."

Now! What about the same problem on the SB-102??
The Tech Bulletins for the SB-102 do not appear to address
this problem. The schematic suggests that lug 1 of relay 1
may *not* be the same as for the HW-100.

Any one have knowledge of this ALC situation on the SB's--
and how to effect a cure?

Thanks.

Allen
--
73 de Rev. Allen, KJ6XH                   El Cajon, CA
**********
Another Heath-en!:  SB-102, SB-600, SB-610
             and more in the plans.

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --