Heath electrolytic problem

WB2TBB ham at CYBERCOMM.NET
Sun Apr 25 07:26:50 EDT 1999


Had these caps been used lately??
Perhaps all would have been ok if it were brought
up slowly with a variac.
If nothing else, you may have received a warning in the form of
a hum or buzz that all was not well.
...Dave
-----Original Message-----
From: , Bob Ensminger <bens at VALINT.NET>
To: HEATH at LISTSERV.TEMPE.GOV <HEATH at LISTSERV.TEMPE.GOV>
Date: Sunday, April 25, 1999 2:31 AM
Subject: Heath electrolytic problem


>I just replaced all electrolytics in SB101 using my other PS from SB102 and
>all worked fine.  I then replaced the 2 small (20 mfd/150v) and the 40
>mfd/450V.  I fired it up and all worked for abt 1 minute then the 40
>mfd/450v blew sending smoke signals and parafin type wax came out.  I had
>checked the cap and it was 44 mfd but I don't have a checker for leakage.
>Could I have another problem or did I just have a bad cap I installed.  I
>have several more used caps to replace.  I will appreciate any help on
>this.
>Thanks,
>Bob, KQ7J
>
>--- --- --- --- --- --- --- --- --- --- --- --- --- --
>To subscribe: listserv at listserv.tempe.gov
>and in body: subscribe HEATH yourfirstname yourlastname
>To unsubscribe:  listserv at listserv.tempe.gov
>and in body: signoff HEATH
>Archives for HEATH: http://www.tempe.gov/archives
>--- --- --- --- --- --- --- --- --- --- --- --- --- --
>

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --




More information about the Heath mailing list