Heath electrolytic problem

[Ed Richards]

Bob;
The small caps may be for the bias supply and go in with the positive end
grounded. Make sure you didn't put them in backwards.
Regards,
Ed Richards


On Sat, 24 Apr 1999 23:10:24 -0700 ", Bob Ensminger" <bens at valint.net>
writes:
>I just replaced all electrolytics in SB101 using my other PS from
>SB102 and
>all worked fine.  I then replaced the 2 small (20 mfd/150v) and the
>40
>mfd/450V.  I fired it up and all worked for abt 1 minute then the 40
>mfd/450v blew sending smoke signals and parafin type wax came out.  I
>had
>checked the cap and it was 44 mfd but I don't have a checker for
>leakage.
>Could I have another problem or did I just have a bad cap I installed.
> I
>have several more used caps to replace.  I will appreciate any help
>on
>this.
>Thanks,
>Bob, KQ7J
>
>--- --- --- --- --- --- --- --- --- --- --- --- --- --
>To subscribe: listserv at listserv.tempe.gov
>and in body: subscribe HEATH yourfirstname yourlastname
>To unsubscribe:  listserv at listserv.tempe.gov
>and in body: signoff HEATH
>Archives for HEATH: http://www.tempe.gov/archives
>--- --- --- --- --- --- --- --- --- --- --- --- --- --

--- --- --- --- --- --- --- --- --- --- --- --- --- --
To subscribe: listserv at listserv.tempe.gov
and in body: subscribe HEATH yourfirstname yourlastname
To unsubscribe:  listserv at listserv.tempe.gov
and in body: signoff HEATH
Archives for HEATH: http://www.tempe.gov/archives
--- --- --- --- --- --- --- --- --- --- --- --- --- --