SB-HW belts

[Joe]

After reading many posts we looked around in the shop and found a WALSCO/GC
electronics CAT.NO 1410-52 (2 belt replacement) for the Webcor 2700 seems
the *closest* I have tried.
(less than 1/3 of 1 preslector increment backlash hot, no slipping)
They come 2 to a set but you can only use one.

EVG #1410-52 was re-stickered over this old item it *may* be the same.
Installed it performed better than the soft pep boys O rings especially when
the radio was hot.
EVG is a division of Russell industries in Oceanside NY.

Small quantities are available at Electronic City at 516-352-7145 they also
have high temperature colored silicon green and blue roll on lamp covers for
#47 and similar dial lamps ask for Charlie

Belt Specs
I.C=4.313
I.C=5.813
THK=.140 (round)

Note:
The fresh belts pulling up the variable capacitors did bring it out bad
connections and overlooked loose screws (next to the vari caps) on the RF
board.
Personally a very good alternative but the old dial string n spring gets the
cigar if you have the time.
Joe

Sponsored by the City of Tempe 

Listserver Submissions:  heath at listserv.tempe.gov
Listserver Subscription: listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"