Help: SB-401

[Chuck W4MIL]

Fellow Heathens--

I have been restoring a very mistreated 401 and finally reached the point
where alignment is the only thing remaining.  New caps, New tubes, ALL
crystals installed for stand alone operation, wafer switches cleaned, et.
al........

The problem I'm having is in the Carrier Null adjustment.  The R and C
components just won't allow me to balance the thing.  I get good voltage
readings in the USB position but when switched to LSB, the voltage cannot be
brought to the level achieved in the USB position.  I checked the usual
components-----no problems.  Front-to-back resistance measurements of the 4
diodes in the bridge indicate they are o.k. in that they measure about the
same each.  Tried another LSB crystal and no help.

Anyone got a clue?  Could there be anything in the instructions that may be
printed incorrectly?  I'm open for suggestions/help.

Thanks in advance es 73 de W4MIL

Chuck

k

Sponsored by the City of Tempe 

Listserver Submissions:  heath at listserv.tempe.gov
Listserver Subscription: listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"