keying a SB200

[Wendell Millman]

I have in the past just keyed the SB-200 with my foot switch, works in a
pinch.

Wendell

VY2CC

----- Original Message -----
From: "Mark S Graalman" <wb8jkr at JUNO.COM>
To: <HEATH at LISTSERV.TEMPE.GOV>
Sent: Thursday, September 07, 2000 4:55 PM
Subject: Re: keying a SB200


> Heck, just use a small 5 vdc coil relay keyed by the rig to
> key the amp.
>
> Mark  WB8JKR
>
>
> On Thu, 7 Sep 2000 14:45:57 -0400 Ron Spencer <n4xd at IX.NETCOM.COM>
> writes:
> > Gentlemen,
> >
> > Thanks for reading. Anyone have a tip on how to key a SB200 safely
> > with a
> > solid state (in this case a IC 746) rig? I had found the Harbach mod
> > page
> > but it has a note saying due to illness no new orders  are being
> > taken.
> >
> > Thanks
> >
> > Ron
> > N4XD
> >
> > BTW, thanks to all that replied to my request on modifying the amp
> > to work
> > on 6.
> >
> > Listserver Subscription:listserv at listserv.tempe.gov - "subscribe
> > heath 'name' 'call'"
> > Listserver Submissions: heath at listserv.tempe.gov
> > Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff
> > heath"
>
> Listserver Subscription:listserv at listserv.tempe.gov - "subscribe heath
'name' 'call'"
> Listserver Submissions: heath at listserv.tempe.gov
> Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"
>
>

Listserver Subscription:listserv at listserv.tempe.gov - "subscribe heath 'name' 'call'"
Listserver Submissions: heath at listserv.tempe.gov
Listserver Unsubscribe: listserv at listserv.tempe.gov - -"signoff heath"