HP-23 recap

[Stu Lyon]

Use GOOP to glue them to the original mounting rings. Need to add terminal
strips to accept 2-watt resistors. Requires a little ingenuity but thats
what hams are all about.

I have done exactly what Glen is suggesting and it works out fine. On 3
HP-23s.

73, Stu W6CUX
Winnetka, CA
slyon at pacificnet.net


----- Original Message -----
From: "Charles W. Morehouse" <w4gbw at BREVARD.NET>
To: <HEATH at LISTSERV.TEMPE.GOV>
Sent: Monday, November 05, 2001 8:45 AM
Subject: Re: HP-23 recap


> THATS FINE, HOW ARE YOU GOING TO MOUNT THEM?
> Wayne;
> W4GBW
>
> Glen Zook wrote:
>
> > NO, I DIDN'T MAKE A MISTAKE!
> >
> > Check page 273 of Catalog 607 from Mouser.
> >
> > You will see that part number 5985-85-450V120 IS a 450
> > volt 120 mfd capacitor.  Mouser puts the voltage and
> > the value of any capacitor that they sell at the end
> > of the part number.  In this case the 450V120
> > indicates a voltage rating of 450 volts and a capacity
> > value of 120 mfd.
> >
> > These work fine in the HP-23.
> >
> > Glen, K9STH
> >
> > --- "Charles W. Morehouse" <w4gbw at brevard.net> wrote:
> > > Glenn,
> > > You made a slight error. The pc board mount you
> > > mentioned is actually  a
> > > 180uf@ 250 vdc. At 450 vdc there is only 100 and
> > > 150uf. The cap I mentioned
> > > is the closest that Mouser has and they work fine.
> > > Just the cost. 73.
> >

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://interactive.tempe.gov/archives/HEATH.html