SB-104A problem

[R. Schmitz]

Hello dear OM´s
Mike,w8krr
Mike,wg8vge
Kees,K5bcq
Brad
Charles,ka8jvx
Dave,w8dlk,hope,I have nobody forgotten.
Thank You all for Your support!
Spent some time with The SB-104A,but not solved the problem (Low PWR-output 
on 20 and 15m)
What I have done:
I connected the PA out Jack directly to a dummy,passing ALC/Output 
Circuit-board: Same results.Out max 25W ,believe yesterdays reading of abt,40 
W was very optimistic. Increased abit during transmitting.
No greater difference between the band (upper and lower part).
I believe, the bug is in IF Board "C".
C337 and 333 are variable. I tried to change a bit and found a very sharp 
maximum on 15 and 20 .Each only 1 or two degree.Only a touch with the 
screwdriver made the difference from "full"power to nothing.But max20W.
Never had so sharp result during alignment of any rig.Because I have no 
extender board,I had to remove the circuit several times,always making just 
"one touch"with the screwdriver.
 After making new solder to the circuit no results.
Oscillator coils L405 and L403 seem to be adjusted well.
If You have no better ideas,I would like to change the switching diodes 
D327-D324. 
They are Type DRS-110 (Heath part57-64).Has anybody an idea, which type of 
Diode from today one should use??
Thank You for all the help!
Any good ideas still welcome........
Best 73´s de Randolf,DL6KAI

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://interactive.tempe.gov/archives/HEATH.html