Looking for 200 ohm linear taper pot (panel mount)

[Richard Post]

Bob,

Make sure it isn't wirewound.
Yes, I admit to finding that out the hard way :-)

Had no manual, just the QST review which had the schematic.

73,

Rich
________________________________
Boatanchor Pix - KB8TAD
<http://switch.to/BA>



At 10:55 AM -0500 11/5/03, Bob, WB2UJD wrote:
>Folks,
>
>Having little to no luck finding a 200 ohm linear taper panel mount pot for
>my less-than-original HD-1422.  I have information that it is a heath p/n
>10-1234, but know better than to hope for one of these.
>
>I would be love to know who is making an equivalent currently.  Seems the
>closest I can find is 250 ohms.  Anyone have any ideas?
>
>Bob, WA2T
>
>-----------------------------------------------------------
>This list is a public service of the City of Tempe, Arizona
>-----------------------------------------------------------
>
>Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
>To post - HEATH at LISTSERV.TEMPE.GOV
>Archives - http://interactive.tempe.gov/archives/HEATH.html

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://interactive.tempe.gov/archives/HEATH.html