SB-401
nv4t
nv4t at BELLSOUTH.NET
Mon Oct 11 15:14:51 EDT 2004
I'll beton the xtal osc.coil adjustment--been there,done that!
NV4T
----- Original Message -----
From: "Mark Graalman WB8JKR" <wb8jkr at JUNO.COM>
To: <HEATH at LISTSERV.TEMPE.GOV>
Sent: Monday, October 11, 2004 10:17 AM
Subject: Re: SB-401
> No, the relay wouldn't do that. I'd look at the bandswitch
> and the HFO oscillator, but I'd bet on the bandswitch.
>
> Mark WB8JKR
>
> On Tue, 12 Oct 2004 07:59:34 -0400 Ray Friess <rayfri at HIGHSTREAM.NET>
> writes:
> > Mark:
> > Wonder if that would apply to my situation too? I have power out
> > on
> > 80 and 40... but
> > zero... zilch ... on 15 through 10. Glen suggested the driver
> > tube
> > ..... Wondering if the relay
> > could cause that too. Doesnt seem logical... if it would show
> > power
> > on 80 and 40 the relay
> > wouldnt be the problem would it?
> > Ray wa7itz
> >
> > Mark Graalman WB8JKR wrote:
> >
> > > Terry,
> > >
> > > A lack of idle current would have nothing to do with
> > >the alignment, neither would intermittent operation
> > >unless the HFO was set incorrectly. I'd take another
> > >look at the relay and MAKE SURE the contacts are
> > >mating properly. I'd also check the bias set pot and
> > >make sure there isn't an intermittent there that would
> > >occasionally place the unit in a cutoff state.
> > >
> > >73, Mark WB8JKR
> > >
> > >
> > >On Sat, 9 Oct 2004 21:00:59 EDT Terry England <W9cau at AOL.COM>
> > writes:
> > >
> > >
> > >>Hello, i've got a SB-401 that transmits sometimes and than it
> > quits
> > >>when you
> > >>turn it off or change bands. But sometimes it will work after you
> > >>turn it
> > >>off or change bands. I have cleaned the switches and relays and it
> > >>still does
> > >>the same thing. If i switch the mode switch back and forth
> > sometimes
> > >>it will
> > >>start working again, and some times not. Also there is no ideling
> > >>current when
> > >>this stops working also. When it works it works fine and everyone
> > >>says it
> > >>sounds great. My next step i think is a re-alinment of the
> > >>transmitter.To i have
> > >> noticed that the output is down a little and other times it is up
> > a
> > >>little.
> > >>It shows 60w sometimes than 75w and other times 95w. Any other
> > >>ideas? I am
> > >>useing this 401 with a SB-303 as far as i know these two have
> > been
> > >>used
> > >>together since they were built. Thank you all for reading. Terry
> > >>w9cau
> > >>
> > >>
> > >
> > >-----------------------------------------------------------
> > >Products bought, sold or traded here is the responsibility of the
> > >parties involved. This list and the City of Tempe are not
> > responsible
> > >for losses or misrepresentations of any kind. Buyer beware!
> > >
> > >-----------------------------------------------------------
> > >This list is a public service of the City of Tempe, Arizona
> > >-----------------------------------------------------------
> > >
> > >Subscription control -
> > http://www.tempe.gov/lists/control.asp?list=HEATH
> > >To post - HEATH at LISTSERV.TEMPE.GOV
> > >Archives - http://interactive.tempe.gov/archives/HEATH.html
> > >
> > >
> > >
> > >
> >
> > -----------------------------------------------------------
> > Products bought, sold or traded here is the responsibility of the
> > parties involved. This list and the City of Tempe are not
> > responsible
> > for losses or misrepresentations of any kind. Buyer beware!
> >
> > -----------------------------------------------------------
> > This list is a public service of the City of Tempe, Arizona
> > -----------------------------------------------------------
> >
> > Subscription control -
> > http://www.tempe.gov/lists/control.asp?list=HEATH
> > To post - HEATH at LISTSERV.TEMPE.GOV
> > Archives - http://interactive.tempe.gov/archives/HEATH.html
> >
>
> -----------------------------------------------------------
> Products bought, sold or traded here is the responsibility of the
> parties involved. This list and the City of Tempe are not responsible
> for losses or misrepresentations of any kind. Buyer beware!
>
> -----------------------------------------------------------
> This list is a public service of the City of Tempe, Arizona
> -----------------------------------------------------------
>
> Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
> To post - HEATH at LISTSERV.TEMPE.GOV
> Archives - http://interactive.tempe.gov/archives/HEATH.html
>
-----------------------------------------------------------
Products bought, sold or traded here is the responsibility of the
parties involved. This list and the City of Tempe are not responsible
for losses or misrepresentations of any kind. Buyer beware!
-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------
Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://interactive.tempe.gov/archives/HEATH.html
More information about the Heath
mailing list