[Heathkit] Differntial earth

Duane Fischer, W8DBF dfischer at USOL.COM
Sun Feb 5 00:34:11 EST 2006


This was not the problem OM, see my previous post about the lightning 
hitting a tree, then the soil and through the soil we go, up the ground rods 
etc.
----- Original Message ----- 
From: "Steve Beveridge" <steve.b at internode.on.net>
To: "Duane Fischer, W8DBF" <dfischer at usol.com>; "Robert Dorchuck W6VY" 
<w6vy at verizon.net>; <HEATH at LISTSERV.TEMPE.GOV>; "Heathkit" 
<heathkit at mailman.qth.net>
Sent: Saturday, February 04, 2006 5:15 PM
Subject: [Heathkit] Differntial earth


>
> Greetings folks,
>
> This little snippet from Duane is an interesting/unfortunate observation
> which has a very powerful message.
>
>>due to lightning getting into the Shack via my ground rod system. I did
>>not disconnect the ground during an  electrical storm. Unhooked all
>>electrical connections from wall outlets,  disconnected all antennas >and
> set switches to ground enable the Poly Phasers etc. You ground >them to
> protect them and them must disconnect the ground to
>> protect them! Sigh.
>
> Everything seems to be right, but the problem was probably inside the
> "boxes". In effect, poor earth connections between boards within the 
> radio,
> etc. can mean that there are small (probably very small) resistances 
> between
> the original earth and the "earth" which the board sees. At the sort of
> potentials associated with lightning strikes, this means that there is a 
> PD
> between true earth and the earth as seen by the board - thus a 
> 'differential
> earth'. We know that PCB screws come loose - as may be seen by the myriad
> 'fixes' which simply involve re-tightening PCB screws.
>
> I have been doing a total rebuild on a TS-850 which suffered a serious
> lightning surge through the house wiring - not mine fortunately. This was 
> a
> 'not-commercially-repairable' moment-of-weakness purchase (from the
> insurance company) on my behalf.
>
> There were quite substantial earth tracks 8 mm wide (or ~1/3") which had
> simply been blown away, leaving gaps of 3 mm (1/8"). In one instance, 
> there
> were three blown sections in no more than 25 mm (1") of track. I am not
> exactly sure how the rig was earthed, but suspect it had been earthed
> through the PS, which was blown beyond repair. Most of the SMD transistors
> on the IF board looked like little carbon blocks (and tested the same!).
> Electros 150 mm (6") away had been blown up. A protection diode (on a
> different board), nearly as big as my (average-sized) little finger, was 
> in
> full conducting mode.
>
> It seems as though if everything goes "up" then "down" (with respect to
> genuine earth) at the same time, there is no (little?) damage. However, 
> even
> a slight 'lag' in the return to true earth potential leads to damage. That
> energy has to go somewhere.
>
> A colleague (ex RF design and manufacturing engineer) always uses the 
> outer
> braid of RG58 to earth boards within his radios. Doesn't rely on the 
> typical
> push-on connectors. Sounds like a lot of hard work, but it seems to do the
> trick.
>
> The 850 is nearly there, but this has been a valuable learning foray into
> something I had always taken as a fairly simple aspect of out hobby - the
> earth!
>
> Cheers
> Steve
> VK2XWL
>
>
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
> $$ See the vintage area on the HCI web site - http://www.w9wze.org $$
> Heathkit mailing list
> Heathkit at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/heathkit
>
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.371 / Virus Database: 267.15.0/249 - Release Date: 2/2/2006
>
> 

-----------------------------------------------------------
Products bought, sold or traded here is the responsibility of the
parties involved.  This list and the City of Tempe are not responsible
for losses or misrepresentations of any kind.  Buyer beware!

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://listserv.tempe.gov/archives/HEATH.html




More information about the Heath mailing list