SB-610 Scope Receive Pattern Amplification

[Peter A Markavage]

Years ago I needed one when I wanted to connect the SB-610 to my Kenwood
R-599D. I just built a typical 2 or 3 stage transistor voltage amp on a 1
inch perf board and mounted it in the receiver. Roughly from the early
60's to whenever, the ARRL handbooks had these typical circuits in the
semiconductor section. No real rocket science in the designs.

Pete, wa2cwa

On Mon, 20 Nov 2006 11:32:29 -0500 carl lowry <l_carlj at BELLSOUTH.NET>
writes:
> Looking for a small circuit , perhaps an OP-AMP type which can be put 
> inline
> between the Receiver IF Output over to the Vertical RCA Input jack 
> on the back
> of the SB-610 which will increase the pattern height (enlarge) on 
> the scope's CRT.
> Has anyone come up with such a circuit or is any member making them 
> ?
> Thanks & Best of the Thanksgiving 73s
> Carl, k4zrd

-----------------------------------------------------------
Products bought, sold or traded here is the responsibility of the
parties involved.  This list and the City of Tempe are not responsible
for losses or misrepresentations of any kind.  Buyer beware!

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.asp?list=HEATH
To post - HEATH at LISTSERV.TEMPE.GOV
Archives - http://listserv.tempe.gov/archives/HEATH.html