SB-201/200 no output on any band

[Wilson Lamb]

What happens when you tune the plate tank?
Sounds like broken wire on bandswitch, or such.
Do you see the excitation coming through if you drive it with the plate off?
WL
----- Original Message ----- 
From: "Tom Chesek" <tchesek at EPIX.NET>
To: <HEATH at LISTS.TEMPE.GOV>
Sent: Saturday, October 18, 2008 5:40 PM
Subject: SB-201/200 no output on any band


I have an SB-201 which was converted to an SB-200 equivalent with a complete 
bandswitch swapout. I cannot tell you if it ever worked after the swap. This 
amp has the Harbach power supply mod and antenna relay including the 
resistor change that comes with the relay kit. The tubes are a pair of 
Cetrons which are soft but verified as working in my other SB-200 amp. Using 
the Taylor tubes from my SB-200 make no difference at all. There is no 
output on any band. I've cleaned the bandswitch with Deoxit, verified that 
the wafers are aligned with each other corectly, and verified that each 
contact has good wiping action. I have verified the -2vdc bias by measuring 
with a DVM and get a reading of -1.78vdc. The filament voltage measured at 
the tube side of the bifilar choke measures 6.72vac. The HV reads just under 
2400vdc on the built in meter. The idling plate current reads about 98ma. 
PC1 & PC2 both have NOS carbon resistors. R21 and R22 are new also.

I've tried drive on each band from 30 watts to 100 watts with no output 
measured on the amps' meter or on the watt meter inline to the 50 ohm 
antenna load. If I drive it with higher power, such as 100 watts, the tubes 
will start to "cherry up" in color if I keep the key down for 30 seconds or 
so. It almost appears to the that no rf is passing beyond C24 but I have 
swapped that cap with the one in my working SB-200. All screws have been 
tightened to be sure the ground paths are intact.

Nothing is going up in smoke so where is my output? This is driving me nuts!

73 and Tnx,

Tom K3TVC

ps: for what it is worth I know that at one point this amp was modified for 
11 meter use and then changed to the current SB-200 configuration.


-----------------------------------------------------------
Products bought, sold or traded here is the responsibility of the
parties involved.  This list and the City of Tempe are not responsible
for losses or misrepresentations of any kind.  Buyer beware!

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.aspx?list=HEATH
To post - HEATH at LISTS.TEMPE.GOV
Archives - http://lists.tempe.gov/archives/HEATH.html 

-----------------------------------------------------------
Products bought, sold or traded here is the responsibility of the
parties involved.  This list and the City of Tempe are not responsible
for losses or misrepresentations of any kind.  Buyer beware!

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.aspx?list=HEATH
To post - HEATH at LISTS.TEMPE.GOV
Archives - http://lists.tempe.gov/archives/HEATH.html