SB-102 - more troubles

[Kenneth G. Gordon]

On 14 Jul 2009 at 11:36, Brian Wood wrote:

> Well, the S-meter is now working great! The final solution was to flip
> the mode switch to CW and back to USB, which means the switch was
> dirty. I now am getting fine readings on band noise and signals of
> various strength.

Good, Brian. It sounds like you need to buy a large-ish can 
of DeOxit and apply it (sparingly) in appropriate places.

> 
> However, another problem has surfaced. Now, as I tune across the band,
> I find it hard to tune a signal in because it "warbles" as I get
> close. I have to move the dial back and forth near the signal until it
> stabilizes. Since the LMO is a preassembled solid-state one, I am
> hesitant to open it up. I suppose the dial could be slipping a little
> and I will check this as soon as I can, although visually it seems OK.
> Before I dig into it, I thought I'd check to see if anyone on the list
> has seen this same problem.

This is and WAS a very common problem with that 
particular LMO. 

I have that problem, and it was mentioned often in the ham 
literature of the time.

Since it is spot-welded shut, you can peel the aluminum foil 
tape off the various access holes and spray some contact 
cleaner or DeOxit into the bearings of the tuning cap.

> The dial calibration is also off pretty far - with the calibrator on,
> I have to move the hairline about 1/2" to the right.

What you need to do to center the hairline is to zero beat 
your calibrator at a 100 Khz point, then CAREFULLY 
loosen the set screw that hold the dial in place, and without 
disturbing the zero, swing the entire dial-plate until the 100 
Khz point is exactly centered.

You will (guess how I know this?) have to do that several 
times until it gets to the correct spot.

> The upper dial is
> off too, which I recall being a typical issue with SB/HW-10x rigs. But
> they don't seem to change with use, so I don't really think they are
> slipping.

Don't worry about that one: it is just supposed to give you 
an indication. It was never intended to be very accurate.

Ken Gordon W7EKB

-----------------------------------------------------------
Products bought, sold or traded here is the responsibility of the
parties involved.  This list and the City of Tempe are not responsible
for losses or misrepresentations of any kind.  Buyer beware!

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.aspx?list=HEATH
To post - HEATH at LISTS.TEMPE.GOV
Archives - http://lists.tempe.gov/archives/HEATH.html