[Heath] SB rubber feet and plastic risers.

[G3OOU at aol.com]

Hi Rob
 
Take a look at this site:  http://www.ultrawebb.com/OHP/
 
The riser could be turned up on a small lathe using a hard plastic or even  
a hard wood painted black.
 
73

Bob

Bob F Burns G3OOU
C  Eng, FIET, MSE
G-QRP 6907
Secretary of Crystal Palace Radio &  Electronics Club: www.g3oou.co.uk
Technical web site:  www.qsl.net/g3oou
@BobFBurns on Twitter: http://twitter.com/BobFBurns  

 
In a message dated 16/12/2013 16:16:36 GMT Standard Time,  
rsmyers at rogers.com writes:

1. Does  anyone know where I can get proper replacement rubber feet for my
Heath SB  gear - or if not,  what the closest available substituted is  out
there?

2.  Same question for the plastic risers in  general.  But in particular, I
especially need the shorter style  plastic piece that was available for use
in the rear leg positions on SB  equipment whose cabinets were not as deep 
as
it was for, say, an  SB-401/SB-303 pair that you might be using with them
with.  It allows  the less deep cabinets to have the same slant on their
front panels as the  deeper cabinets.  For example, if you were matching an
SB-401/303 pair  with an SB-650 display, or an SB-600 speaker, etc., when 
all
of them have  the tall front risers installed.

Thanks,
--- Rob  Myers
VE3JQL


_______________________________________________
Heath  mailing  list
Heath at puck.nether.net
https://puck.nether.net/mailman/listinfo/heath

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/heath/attachments/20131216/46c5a52e/attachment.html>