[Heath] Heath items FS

[Ken, W8EK]

Heath Items For Sale:

SB-614 Monitor Scope, Dip Meter Coils, SWR Bridge, Parts
for SB-220/221, Parts for HM-102/2102, Parts for SB-630,
Parts for HD-15, Original Heath Manuals, and more


Heath SB-614 Monitor Scope:

This unit matches the SB line of Heath equipment, and is
made to monitor your transmitted signal. It uses a 3 inch
CRT. It is ideal to use with one the linear amplifiers above,
or any other linear.

Heath has designed at least three different monitor scopes.
This is the latest model, and is all solid state, except for the
CRT.

I have used it to monitor transmit signals, and it works great.
Cosmetically, it looks great as well. The graticule is sharp and
nice. No scratches or defects that I can find. Pristine!

With paper work for $150.


Heath HM-15 SWR Bridge
This SWR meter covers the HF bands, and cosmetically matches
the Heath SB and HW line.  This one works fine, and looks close
to perfect.  With paper work for $20.


Coils for Heath HM-10 A Dip Meter:
Does someone have an HD-10 A "Tunnel Dipper" without the coils?
It seems that the coils for the dip meters often "walk away".
If yours did, this is just what you need.  It is the complete set
of coils, but it is missing the meter unit itself.  $15


Heath SB-220 / SB-221 parts:

Heath SB-221 logo
This is the logo with the Heath name and SB-221, that goes
in the upper left of the front panel. It looks perfect.
No scratches or defects. $15

Heath SB-220 original metering and rectifier PC board
This is the original board from an SB-220 HF amp that was replaced
with one of the Harbach boards. Almost all of the resistors on this
board drift over time, and result in inaccurate meter readings. This
board has had ALL of the metering resistors replaced with 1% or 2%
precision resistors. The 4.7 Meg resistors in the high voltage
measuring section have been replaced with resistors rated to take the
high voltage, as well as being more precision. This board includes
the 10 watt zener diode. This effectively makes the board very
similar to the Harbach board, which they sell for $38. Buy this
board for only $25.

Original metering rectifier board, as above, but does NOT have the
10 watt zener diode included. $20

Original 10 watt 5.1 volt zener diode for SB-220. $10

SB-220 grid choke (1 mh, Part # 45-4, RFC 4 and 5)
These often go up in smoke when there is a tube problem.
These are fine, with no problems. $5 each


Knobs for SB series:
Dark green knobs with aluminum skirt, 1 1/8 inch in diameter.
These are the medium size knobs used in all of the SB series of
transceivers, receivers, transmitters and accessories.
Two available at $5 each.


ORIGINAL Heath manuals:

These are original manuals only, for Heath equipment.
They are in very nice condition. Schematic is in the book.

GD-600 Photoelectric Light Switch, $4
HD-1234 Coaxial Switch, $3
HD-1481 Remote Coax Switch, $7
HN-31 Cantenna RF Dummy Load, $7
HW-2021 2 meter HT, No check marks, $9
HW-2036 2 meter transceiver, partial manual, $8
IN-17 Decade Resistance Box, $4
SB-610 Monitor Scope, $12
SB-221 HF Linear Amplifier, $25

These are original Heath manuals only.


Heath HM-102/HM-2102 Wattmeter Parts (all are common to both meters):

Outer clam shell cabinet (left and right sides plus top) in nice
condition. $12

Set of four feet, w/hardware. $8

Three position SWR/Power switch
Switches between SWR, high and low power. $7


I have many Heath SB-630 Station Console parts available.
Please let me know what you need.


I also have parts from a Heath HD-15 phone patch available.
What do you need?



I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.

Prices do not include shipping from Florida.
On the heavy items, pickup near Ocala FL is much preferred.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400