<div dir="ltr">Yesterday I managed to get all of the power transformer wires disconnected and ran a continuity test on all of the windings.  The 120vac primary checked out indicating a very low resistance which, I think, shows it's fine.  <div><br></div><div>There are two additional primary windings, one for 12 and one for 6 volt operation that utilize a split-reed, dual-interrupter vibrator.  Resistances between connections for each of these windings all showed very low (0.5ohm) resistances.  Since I won't be using either 6 or 12 volts for this rig, values here really don't matter, I don't think :).  </div><div><br></div><div>The resistance between ends of the secondary winding is 52ohms and between the end and the center tap it's 26.6ohms so I think the secondary is ok as well.<div><br></div><div>I would like to apply power to this transformer to ensure is is indeed working as it should.  Should I use a Variac/isolation transformer setup to do this?</div><div><br></div><div>The 6 and 12 volt windings require the use of the vibrator so, if this isn't in the circuit, there should be no interaction, correct?  </div><div><br></div><div>There is a tap in the 6-volt primary winding that is used to obtain filament voltage.  I should be able to measure this voltage on the filament lines once 120vac is applied, correct?</div></div><div><br></div><div>I hope I haven't exceeded my question limit for one post:)</div><div><br></div><div>Doug  VE7DRF</div></div>