<div dir="ltr">The replacement parts for the DX-60B arrived today, R35 the 270 ohm, 2W resistor, R34, the 100 ohm 7W resistor and C19 a 0.001uf, 1.4kv disc ceramic cap, all of which are in the power supply circuit.  I installed them all and proceeded to the test phase.  Everything went according to the manual as far as the tune-up was concerned.<div><br></div><div>Measuring the output, the rig is putting out about 45 watts to a dummy load..  The spec says the input power is 90 watts so I would think the actual rf output should be around 70-75 watts.  Not sure why this is happening.  I'm getting the proper grid and plate current to the 6146 which tests good with a tube tester.  Any ideas here?</div><div><br></div><div>Anyway, it's good to have the old girl running again and I really appreciate the help I received.</div><div><br></div><div>Doug</div><div>VE7DRF</div></div>