[j-nsp] Problems commiting changes to firewall filter

[Walter De Smedt]

After updating a firewall filter with a new term, i get following error
msg in the syslog:

Jul 18 18:10:48 xxxxx mgd[1041]: UI_COMMIT_QUIT: User 'wds' performed
'commit and-quit'
Jul 18 18:10:49 xxxxx /kernel: BAD_PAGE_FAULT: pid 1052 (dfwc), uid
0: pc 0x804f366 got a read fault at 0xa, x86 fault flags = 0x4
Jul 18 18:10:49 xxxxx /kernel: Trapframe Register Dump:
Jul 18 18:10:49 xxxxx /kernel: eax: 00000001 ecx: 00000010   edx:
00000002  ebx: 00a10000
Jul 18 18:10:49 xxxxx /kernel: esp: bfbff314 ebp: bfbff32c   esi:
080610e8  edi: 08084680
Jul 18 18:10:49 xxxxx /kernel: eip: 0804f366 eflags: 00010246
Jul 18 18:10:49 xxxxx /kernel: cs: 001f      ss: 002f        ds: 002f
es: 002f
Jul 18 18:10:49 xxxxx /kernel: fs: 002f      trapno: 0000000c
err: 00000004
Jul 18 18:10:49 xxxxx /kernel: Page table info for pc address
0x804f366: pde = 0x1ca01067, pte = 9dc3425
Jul 18 18:10:49 xxxxx /kernel: Dumping 16 bytes starting at pc
address 0x804f366:
Jul 18 18:10:49 xxxxx /kernel: 8b 42 08 eb 13 90 8b 4a 18 8b 42 14 03
41 08 80
Jul 18 18:10:49 xxxxx dcd[1051]: DCD_FW_COMPILER_EXIT: dfwc exited
with signal 11

Jul 18 18:10:49 xxxxx mgd[1041]: UI_CHILD_EXITED: Child exited: pid
1051, status 1, command '/sbin/dcd'

when i remove the new term, i can commit. I'm sure there is no problem
with the term itself as i applied it in the same filter on another
router. 

Any comments are appreciated.

thanks,

--
walter