[j-nsp] router load

[Hitesh Patel]

Hi David,

Possibly this is what you need

Show chassis routing-engine

show chassis ?
Possible completions:
  alarms               Show alarm status
  cos                  Show CoS information
  craft-interface      Show craft interface status
  environment          Show environmental status
  feb                  Show Forwarding Engine Board status
  firmware             Show firmware version information
  fpc                  Show flexible port concentrator status
  hardware             Show hardware inventory information
  mac-addresses        Show MAC addreses
  routing-engine       Show Routing Engine status

Regards

Hitesh Patel
Operations Engineer



-----Original Message-----
From: David Brazewell [mailto:dbrazewell at easynet.co.uk] 
Sent: 03 November 2003 11:49
To: juniper-nsp at puck.nether.net
Subject: [j-nsp] router load


Hi

Does anyone know if there is a junos equivalent command for the cisco ios
"show processes cpu" command?

Ive seen the "show system processes extensive" output but it doesnt break
down the rpd process so all you know is that your routing engine is using up
your cpu but you dont know which part of the rpd process (bgp, ospf etc) is
actually using what.


thanks

david

_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/juniper-nsp