[j-nsp] 4 Port E1 ( Urgent)

[Usman Tahir]

Hi

We have an M7 router with following config 


7iBASE-AC-2FETX	M7i Base Unit: 4 PIC slot chassis
PE-4E1-RJ48	4-port E1 PIC (120-ohm RJ48 connectors) with PIC ejector
1


Not being to familiar with juniper  E1 , I was wonder if someone could tell
me if I want to connect the E1 port to a MUX that is connected to a cisco
router , this cisco router is configured with PPP circuit and 4 timeslots ,
would the above hardware support it ? 

If yes , would the above module support multiple PPP circuits on same E1 ?
meaning I can have two cisco routers coming into mux first with 1-4 TS
second with 5-9 TS , and from MUX there is E1 that is connecting to Juniper
E1 port ( above) , will juniper support multiple circuits on 1 E1 port
mentioned above ?
Usman