[j-nsp] Does FE support 100M only?

[Rubens Kuhl Jr.]

I wouldn't use auto-negotiate anywhere.
As to connecting same brand of hardware, I once had auto-neg issues between
the same brand (the one that begins with C :-), so that exception went out
of my book.


Rubens



----- Original Message ----- 
From: "Erik Haagsman" <erik at we-dare.net>
To: "Juniper-NSP" <juniper-nsp at puck.nether.net>
Sent: Friday, February 13, 2004 10:43 PM
Subject: Re: [j-nsp] Does FE support 100M only?


> You can set both duplex as well as linkspeed at the interface level.
> (using the link-mode and speed parameters).
> Frankly, I wouldn't use auto-negotiate on a router, especially not when
> connecting different brands of hardware (non-Juniper to a Juniper).
>
> Cheers,
>
> Erik
>
> On Sat, 2004-02-14 at 01:32, Mike Sumrall wrote:
> > I have a M5 with a 4X FE pic, here's the show chassis:
> >
> > PIC 0   REV 04  750-002992  HA7235   4x F/E, 100 BASE-TX
> >
> > Does this pic only support 100M?  and not 10M?  is it full or half
> > duplex? and does it support autonegotiate?
> >
> > Thanks,
> >
> >  -Mike
> >
> > Mike Sumrall
> > Integrated Communications Concepts
> > Sr. Systems Engineer
> > Work: 714-970-5011
> > Cell: 714-234-3404
> > msumrall at ic2net.net
> -- 
> ---
> Erik Haagsman
> Network Architect
> We Dare BV
> tel: +31.10.7507008
> fax: +31.10.7507005
> http://www.we-dare.nl
>
>
>
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/juniper-nsp
>