[j-nsp] 802.3ad between M5 & Cisco cat3750

[Khawaja, Kashif]

Is layer 3 802.3ad aggregation possible between Juniper & Foundry and
(between Cisco catalysts 6xxx & Foundry :))?


-----Original Message-----
From: Niels Bakker [mailto:niels=juniper-nsp at bakker.net] 
Sent: Monday, January 26, 2004 4:00 PM
To: Robert J. Adams (jason)
Cc: juniper-nsp at puck.nether.net
Subject: Re: [j-nsp] 802.3ad between M5 & Cisco cat3750


>>Correct, an aggregated link must have "vlan-tagging" enabled.
>>
>>FWIW, on a Foundry switch the configuration is as simple as "trunk 
>>server e 1 to 2" to configure an aggregated link.

* radams at siscom.net (Robert J. Adams (jason)) [Mon 26 Jan 2004, 22:41
CET]:
> So you didn't have to configure tagged vlans on the Foundry? What do 
> you
> have the vlan id set to on the juniper?

Well, of course you have to do that too.  The vlan-id's on the Juniper
match the configuration of the switch.  In this particular case:

!
vlan 110 by port
 tagged ethe 1 to 2
!
vlan 130 by port
 tagged ethe 1 to 2
!