[j-nsp] l2circuit QoS

[Raymond Cheh]

One way to achieve this is to map the multiple l2circuits onto a lsp
using community and set up the lsp with the bandwidth (100Mbps) you
want.

http://www.juniper.net/techpubs/software/junos/junos74/swconfig74-vpns/h
tml/l2circuits-config4.html#1061001

Some cautions,

1. the bandwidth policing will be on the lsp alone, using the l2circuit
bandwidth to make sure each l2circuit connection reserve enough
bandwidth helps but it is not required
2. other traffic may use the lsp if you are not careful, in which case,
not all the bandwidth on the lsp (100Mbps) will be used by the
l2circuits. Planning is important.

Hope this helps.

Raymond

> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net [mailto:juniper-nsp-
> bounces at puck.nether.net] On Behalf Of Christian Malo
> Sent: Wednesday, October 26, 2005 11:25 AM
> To: juniper-nsp at puck.nether.net
> Subject: [j-nsp] l2circuit QoS
> 
> Is there a way to bundle multiple l2circuits together and limit the
bundle
> to 100meg/sec?
> 
> 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/juniper-nsp