[j-nsp] l2circuit between vlan-ccc and ethernet-ccc

[Per Ole Klemetsrud]

I believe you can't specify the PW type manually in Junos, specifically 
type 0x0004 Tagged vs 0x0005 Ethernet (raw).

http://www.ietf.org/internet-drafts/draft-ietf-pwe3-ethernet-encap-10.txt


=) PO


On Fri, 28 Oct 2005, Richard A Steenbergen wrote:

> How the heck do you set up an l2circuit between a vlan-ccc interface (.1q
> tagged on the handoff) on one end, and a ethernet-ccc handoff (not .1q
> tagged) on the other end? If you just configure it like normal you get
> EM/encapsulation mismatch on the l2circuit, but since the .1q tag is not
> included in the actual payload put on the LSP, they should actually be the
> same packet internally yes? Doesn't seem to be an issue covered in any
> documentation. :)
>
>