[j-nsp] Redback(LAC) and Juniper (LNS) -- L2TP problem

Ufuk Kahraman ukahraman at gmail.com
Thu Dec 13 02:24:10 EST 2007


Hi Chris,

I have this conf,İ am not using loopback here,


aaa domain-map "test.com"
 router-name default
 ipv6-router-name default
 ip-hint enable
!
profile test
 ip virtual-router default
 ip unnumbered gigabitEthernet 1/0.1
 ppp authentication pap chap
!
virtual-router default
interface gigabitEthernet 1/0.1
 vlan id 111
 ip address y.y.y.y 255.255.255.252
 pppoe
 pppoe duplicate-protection
 pppoe auto-configure
 pppoe profile any smile
!
ip router-id y.y.y.y
no ip source-route
!
hostname deneme
!
l2tp checksum
l2tp tunnel idle-timeout 0
l2tp destination profile "test-profile" virtual-router default ip address
x.x.x.x
 remote host "test-dsl"
  tunnel password 1111
  profile test
  local host deneme
  local ip address y.y.y.y
  enable proxy authenticate
  disconnect-cause

----
Thanks

Ufuk


On 13/12/2007, Chris Hellberg <chellberg at juniper.net> wrote:
>
> Hi,
>
> Could you check that you have a loopback address and authentication type
> (chap, pap or both) configured in your l2tp host profile.
>
> Cheers,
>
> Chris
>
> > -----Original Message-----
> > From: juniper-nsp-bounces at puck.nether.net
> > [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of
> > Ufuk Kahraman
> > Sent: Wednesday, 12 December 2007 8:23 p.m.
> > To: juniper-nsp at puck.nether.net
> > Subject: [j-nsp] Redback(LAC) and Juniper (LNS) -- L2TP problem
> >
> > Hi,
> >
> > There is Redback(LAC) and Juniper (LNS) when we try to
> > connect we are getting this debug print,
> >
> > --------------------------------------------------------------
> > -----------------------------------------------
> > test#sINFO 12/12/2007 17:35:34 l2tp (interface TUNNEL l2tp:2/1078):
> > Processing incoming in-sequence icrq
> > NOTICE 12/12/2007 17:35:34 l2tp (interface TUNNEL l2tp:2/1078/2336):
> > Changing ifOperStatus from LowerLayerDown to Down NOTICE
> > 12/12/2007 17:35:34 l2tp (interface TUNNEL l2tp:2/1078/2336):
> > Changing effective adminState from disabled to enabled NOTICE
> > 12/12/2007 17:35:34 l2tp (interface TUNNEL l2tp:2/1078/2336):
> > Changing mibState from idle to connecting hINFO 12/12/2007
> > 17:35:34 l2tp (interface TUNNEL l2tp:2/1078): Processing
> > incoming in-sequence iccn WARNING 12/12/2007 17:35:34 l2tp
> > (interface TUNNEL l2tp:2/1078/2336):
> > Discarding proxy LCP data in incoming iccn NOTICE 12/12/2007
> > 17:35:34 l2tp (interface TUNNEL l2tp:2/1078/2336):
> > Discarding proxy authenticate in incoming iccn NOTICE
> > 12/12/2007 17:35:34 l2tp (interface TUNNEL l2tp:2/1078/2336):
> > Changing mibState from connecting to disconnecting NOTICE
> > 12/12/2007 17:35:34 l2tp (interface TUNNEL l2tp:2/1078/2336):
> > Changing mibState from disconnecting to idle
> >
> >
> >
> > test#INFO 12/12/2007 18:44:25 l2tp (interface TUNNEL l2tp:2/1080):
> > Processing incoming in-sequence icrq
> > NOTICE 12/12/2007 18:44:25 l2tp (interface TUNNEL l2tp:2/1080/2706):
> > Changing ifOperStatus from LowerLayerDown to Down DEBUG
> > 12/12/2007 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = closeDown,
> > event = up, next state = closed NOTICE 12/12/2007 18:44:25
> > l2tp (interface TUNNEL l2tp:2/1080/2706):
> > Changing effective adminState from disabled to enabled DEBUG
> > 12/12/2007 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = closed, event
> > = open, next state = idle DEBUG 12/12/2007 18:44:25
> > l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = idle, event =
> > icrq, next state = txIcrp NOTICE 12/12/2007 18:44:25 l2tp
> > (interface TUNNEL l2tp:2/1080/2706):
> > Changing mibState from idle to connecting DEBUG 12/12/2007
> > 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = txIcrp, event
> > = txStarted, next state = waitConnected INFO 12/12/2007
> > 18:44:25 l2tp (interface TUNNEL l2tp:2/1080): Processing
> > incoming in-sequence iccn DEBUG 12/12/2007 18:44:25
> > l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = waitConnected,
> > event = iccn, next state = waitUpper DEBUG 12/12/2007
> > 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = waitUpper,
> > event = createUpperFail, next state = txCdnOpen NOTICE
> > 12/12/2007 18:44:25 l2tp (interface TUNNEL l2tp:2/1080/2706):
> > Changing mibState from connecting to disconnecting DEBUG
> > 12/12/2007 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = txCdnOpen,
> > event = reset, next state = txCdnOpen DEBUG 12/12/2007
> > 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = txCdnOpen,
> > event = reset, next state = txCdnOpen DEBUG 12/12/2007
> > 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = txCdnOpen,
> > event = txComplete, next state = resetIdle DEBUG 12/12/2007
> > 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = resetIdle,
> > event = reset, next state = idle NOTICE 12/12/2007 18:44:25
> > l2tp (interface TUNNEL l2tp:2/1080/2706):
> > Changing mibState from disconnecting to idle DEBUG 12/12/2007
> > 18:44:25 l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = idle, event =
> > dying, next state = dying DEBUG 12/12/2007 18:44:25
> > l2tpStateMachine (interface TUNNEL
> > l2tp:2/1080/2706): lnsIncomingSession: state = dying, event =
> > dead, next state = dead
> > -------------------------------------
> >
> > Could you tell me how can i solve this problem, Thanks
> >
> > Ufuk
> > _______________________________________________
> > juniper-nsp mailing list juniper-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/juniper-nsp
> >
>


More information about the juniper-nsp mailing list