[j-nsp] ERX-310 ip-forwarding load errors

[Peter Krupl]

Hi Group,

We have had some strange incidents, where certain routes I the ERX just don't
seem to work. Although they are displayed correctly with si ip route.

I noticed some load errors as shown below, but I don't have a clue what they are about..... (probably something bad...).

--------------SNIP---------------
ERX01-BYN:default:i#sh ip forwarding-table slot 1
Free Memory = 30002 KB (91.56%)
         Virtual Router            Memory(KB)    Load Errors      Status    
-------------------------------- -------------- ------------- --------------
default                          -              -             Not Resident  
i                                2763           112285        Updating      
mgmt                             3              0             Valid         
1001                             -              -             Not Resident  
1005                             -              -             Not Resident  
1013                             -              -             Not Resident  
--------------SNIP---------------

Software version: erx310_7-3-1p0-6.rel


Med venlig hilsen/Kind regards
Peter Åris Krüpl
Netværksspecialist

Ventelo Webpartner
Århusgade 88
2100 København Ø
Denmark
 
+45 35 25 47 54 (Direkte)
+45 70 26 23 00 (Hovednummer)
+45 70 26 23 01 (Telefax)
+45 80 20 75 95 (Kundeservice)
www.ventelo.dk

This correspondence and any attached files are for the sole use of the intended recipient(s) and may contain confidential and proprietary information. If you receive the above communication in error, please delete the message and notify the sender immediately. Do not distribute any part of this e-mail as the confidentiality stipulation adheres even in the event of mistransmission. Ventelo reserves the right to monitor all email communications through its network.
<Note> If you are in doubt if you are the intended recipient please use your magic crystal ball. I might have mistyped the "intended" recipient adress, or maybe not. </Note>