[j-nsp] Issues setting up LACP between M40 and Cisco 6500 CATOS

[Phil Bedard]

You don't need to run a dynamic protocol (PaGP/LACP) to use an  
etherchannel/aggregate interface, just set
mode to "on" on the Cisco end, and do not run LACP on the Juniper end.

Phil


On May 3, 2007, at 11:32 AM, Dan Benson wrote:

> Nicolaj, that would explain my issue.  Thank you.  I am open to
> suggestions on some form of etherchannel between the cisco and the
> juniper, it was my understanding that the juniper and cisco only  
> support
> LACP as being the common protocol.  Was I wrong in this estimation?
> Thanks.. //db
>
> Nicolaj Kamensek wrote:
>> Dan Benson wrote:
>>
>> Hi Dan,
>>
>>> interfaces ae0   vlan-tagging;
>>> aggregated-ether-options {
>>>     link-speed 1g;
>>>     lacp {
>>>         active;
>>>     }
>>
>> do you have FPC or FPC-E? Active LACP is only possible with the
>> enhanced FPC. However, why do you want lacp?
>>
>> Regards,
>> Nico
>>
>>
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp

Phil Bedard
philxor at gmail.com