[j-nsp] Probelm with FXP0 & "commit synchronise"

[Sean Clarke]

Hi Hamid,

  Just add "set system backup-router 10.6.78.65" .. this is assuming
  10.6.78.65 is your next-hop of the fxp0 interface

  It's so the RE can get to the management default gateway at all
  times ... the route will be installed on reboot until a "proper"
  route is known

Cheers
Sean
--

Not so long ago you wrote : 
HA> Hi Everyone,
HA>    
HA>   I would like to know that i did configuration on juniper router
HA> M10i. There are two routing engines. The two fxp0s are configured
HA> with different IPs otherwise everything else in the configuration
HA> is the same. I am getting the following issue when "commit synchronise" is done:
HA>    
HA>  
HA> -------------------------------------------------------------------------
HA>   {master}[edit]
HA>   edit routing options static 
HA> set route 0.0.0.0/0 next-hop 10.6.78.65
HA>   
HA> routerM10i# commit synchronize 
HA> re0: 
HA> configuration check succeeds
HA> re1: 
HA> [edit interfaces fxp0 unit 0 family inet]
HA>   'address 10.6.78.79/27'

HA>   warning: [edit system backup-router] not present. The default route for fxp0 is not installed.
HA> commit complete
HA> re0: 
HA> commit complete
HA>  
HA> ---------------------------------------------------------------------------
HA>    
HA>   Can anyone suggest?
HA>    
HA>   BR//
HA>   HA.
HA>    

HA>  
HA> ---------------------------------
HA> It's here! Your new message!
HA> Get new email alerts with the free Yahoo! Toolbar.
HA>        
HA> ---------------------------------
HA> Luggage? GPS? Comic books? 
HA> Check out fitting  gifts for grads at Yahoo! Search.
HA> _______________________________________________
HA> juniper-nsp mailing list juniper-nsp at puck.nether.net
HA> https://puck.nether.net/mailman/listinfo/juniper-nsp