[j-nsp] Duplex settings for FastE ports

[Kanagaraj Krishna]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,
   Im unable to verify the duplex settings of a FastE link through the
show command. There is no link partner information under negotiation
status, but I'm able to ping the other side interface. Any idea why
this information is not visible?

/xxxx at xxxx> show configuration interfaces fe-0/2/0
description "";
speed 100m;
link-mode full-duplex;
unit 0 {
    family inet {
        address xxx.xxx.xxx.xxx/30;
    }
}

xxxx at xxxx> show interfaces fe-0/2/0 media
Physical interface: fe-0/2/0, Enabled, Physical link is Up
  Interface index: 141, SNMP ifIndex: 81
  Description:
  Link-level type: Ethernet, MTU: 1514, Speed: 100mbps, Loopback:
Disabled, Source filtering: Disabled, Flow control: Enabled
  Device flags   : Present Running
  Interface flags: SNMP-Traps Internal: 0x4000
  Link flags     : None
  CoS queues     : 4 supported, 4 maximum usable queues
  Current address:     Hardware address:
  Last flapped   : xxxxxxxx
  Input rate     : 0 bps (0 pps)
  Output rate    : 0 bps (0 pps)
  Active alarms  : None
  Active defects : None
  MAC statistics:
    Input bytes: 0, Input packets: 0, Output bytes: 9984, Output
packets: 156
  Filter statistics:
    Filtered packets: 0, Padded packets: 0, Output packet errors: 0
  Autonegotiation information:
    Negotiation status: Incomplete

//Kana//
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.7 (Darwin)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFHDzkAOOJ6cNkeR0MRAuPSAKDFqXXyhVoApoTDzLMWXTgbNm0xGgCeJrym
RI7vIJZc7gB4VHbmXHpywbI=
=CJ0i
-----END PGP SIGNATURE-----