[j-nsp] New RE

[Paolo Autore]

show configuration chassis 
no-source-route;
redundancy {
    failover {
        on-loss-of-keepalives;
        on-disk-failure;
    }
    graceful-switchover {
        enable;
    }
}

And under system just do "commit sync"

-----Original Message-----
From: juniper-nsp-bounces at puck.nether.net
[mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Sean Clarke
Sent: Wednesday, October 31, 2007 09:28
To: Youness El Wardi
Cc: juniper-nsp at puck.nether.net
Subject: Re: [j-nsp] New RE

Not sure what you're after here, but if you just do a "commit 
synchronise"  on the master RE, the backup RE will have the same config 
(which is of course recommended)

cheers
Sean


Youness El Wardi wrote:
> Hi guys,
>
> We are installing a new RE on our J20 juniper GGSN. I believe this new
> RE will have the same configuration than the other one already
> installed, but I believe there will be some extra configuration.
> Can any one advice or send an example of a router with 2 Res
configured?
>
> Thanks and best regards
>
>   
>> eRICSSONl 
>>     
> Youness EL WARDI
> Core/IMS Services Engineer
> +21261242426
> youness.el.wardi at ericsson.com
> Ericsson Morocco
> Shadow Building, Sidi Maarouf
> Casablanca-Morocco
>
>
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
>   

_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp