[j-nsp] Multilink connection between Frame Relay and ATM

[Peter E. Fry]

----- Original Message -----
From: "Gökhan Gümüº" <ggumus at gmail.com>
[...]
> I have two links between these M10i and M7i and i want to
> bundle these two link to a one multilink interface.Problem
> is one side of my link is configured with encapsulation
> frame-relay and one side of link is terminated on my ATM
> card.
> 
> Is there way to configure these two links as a one
> multilink interface?

  I can imagine possibilities.  If the links are run through
a switch which is performing FRF.8 frame-ATM interworking,
it may be possible to run PPP on top of the frame and ATM (I
believe I set it up at one point on Cisco equipment, some
years back), but it's a pretty obscure config, and it's
generally easier to bundle the links in the switch (FRF.16
MFR -> single ATM PVC, as I'm assuming multiple smaller
links on the serial side to a larger ATM interface, you said
"ATM card" and not "cards", and "IMA" and "Juniper" don't
mix).  And then there's always ECMP.

Peter E. Fry