[j-nsp] IPv6 link-local addresses
Eric Van Tol
eric at atlantech.net
Tue Sep 18 17:47:23 EDT 2007
Hi,
Is there a way to manually set the link local address of an interface in
8.x? I am running into a problem where I have T1 interfaces connected
through a CT3 and they both have the same link local address. This is a
back-to-back CT3 using logical-routers:
admin at m20-re0# run show interfaces t1-0/1/0:0 | match fe80
Destination: fe80::/64, Local: fe80::2a0:a5ff:fe28:f
[edit]
admin at m20-re0# run show interfaces t1-0/1/1:0 | match fe80
Destination: fe80::/64, Local: fe80::2a0:a5ff:fe28:f
The intended result is to have different addresses so my OSPF3
adjacencies can come up:
Sep 18 21:34:49.963624 OSPF packet ignored: Our interface address is
source address fe80::2a0:a5ff:fe28:f
I've attempted to use the 'preferred' keyword on the v6 address, but
that didn't work.
Any insight would be appreciated.
Thanks,
eric
More information about the juniper-nsp
mailing list