[j-nsp] MPLS RSVP Juniper to Cisco

[Supanekar, Harsh V]

Hi,
 
Has anyone configured RSVP LSP between Juniper M series router and the
Cisco ISO SR series router.
>From the error message on the Juniper side (see below), it show that the
Cisco side is not configured for RSVP.  
Does anyone have any ideas?
 
Thanks
 
 
juniper at LAB1# run show mpls lsp detail 
Ingress LSP: 1 sessions
 
20.20.20.1
  From: 10.20.20.1, State: Dn, ActiveRoute: 0, LSPname: j-c
  ActivePath: (none)
  LoadBalance: Random
  Encoding type: Packet, Switching type: Packet, GPID: IPv4
  Primary                    State: Dn
    SmartOptimizeTimer: 180
    2 Apr 21 19:17:10.383 10.10.90.2: Non-RSVP capable router
detected[50 times]
Total 1 displayed, Up 0, Down 1

 
CISCO CONFIGURATION
 
mpls traffic-eng tunnels

interface Tunnel1
 ip unnumbered Loopback10
 tunnel destination 10.20.20.1
 tunnel mode mpls traffic-eng
 tunnel mpls traffic-eng autoroute announce
!
interface Loopback10
 ip address 20.20.20.1 255.255.255.255
 ip ospf 1 area 0
!
interface GigabitEthernet0/0/0
 mtu 9178
 ip address 10.10.90.2 255.255.255.252
 ip ospf 1 area 0
 negotiation auto
 mpls traffic-eng tunnels
 mpls ip
 no cdp enable
 ip rsvp bandwidth
 ip rsvp resource-provider none
 
!
router ospf 1
 log-adjacency-changes
 mpls traffic-eng router-id Loopback10
 mpls traffic-eng area 0
!
 
JUNIPER CONFIGURATION
 
ge-0/2/0 {
    mtu 9192;
    unit 0 {
        family inet {
            address 10.10.90.1/30;
        }
        family mpls;
    }
}
 
lo0 {
    unit 0 {
        family inet {
            address 10.20.20.1/32;
        }
    }
}
 
routing-options {   
    static {        
        route 0.0.0.0/0 next-hop 10.10.90.2;
    }               
}                   
protocols {         
    rsvp {          
        interface ge-0/2/0.0;
    }               
    mpls {          
        label-switched-path j-c {
            to 20.20.20.1;
            no-cspf;
        }           
        interface ge-0/0/0.0;
        interface ge-0/2/0.0;
    }               
    ospf {          
        traffic-engineering;
        area 0.0.0.0 {
            interface ge-0/2/0.0;
            interface lo0.0;
        }           
    }               
}            


This e-mail and its attachments are confidential and solely for the
intended addressee(s). Do not share or use them without Fannie Mae's
approval. If received in error, contact the sender and delete them.