[j-nsp] Serial Question

[Lakshminarayanan P]

Hi Lee,

This might be a known issue. Have you buzzed Juniper TAC about this?

Cheers
Lakshmi

2008/6/17 Lee Hetherington <lee.hetherington at redtechnology.com>:

> Hi All,
>
> I have a J2320-JH which is replacing an aging Cisco 3640.  I am having
> trouble bringing up an x.21 leased line.  It brings up the line, but in
> cisco terms not the protocol.  It keeps telling me on my subinterface
> "flags: down".
>
> Below are my cisco and juniper configs.  Anyone any ideas, the isp is
> being particularly un-helpful.
>
> Cisco:
>
> !
> interface Serial0/0
>  bandwidth 2048
>  no ip address
>  encapsulation frame-relay
>  no ip mroute-cache
>  keepalive 5
>  no fair-queue
>  frame-relay lmi-type ansi
> !
> interface Serial0/0.16 point-to-point
>  description Telstra Circuit
>  ip address 154.32.xxx.81 255.255.255.252
>  no cdp enable
>  frame-relay interface-dlci 16 IETF
> !
>
>
> Juniper:
>
> se-1/0/1 {
>        description Telstra;
>        mtu 1500;
>        encapsulation frame-relay;
>        serial-options {
>            clocking-mode loop;
>        }
>        unit 0 {
>            description "Telstra Serial Circuit MXFS203988";
>            point-to-point;
>            dlci 16;
>            family inet {
>                address 154.32.152.81/30;
>            }
>        }
>    }
>
> Many Thanks,
>
> Lee
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>