[j-nsp] LACP

[david.roy at orange-ftgroup.com]

Hi all,
 
I've A GEC established between a T640 and Cisco Switch CatOS 
 
On the Cisco CatOS, LACP is configured in mode "ON" and on the T640 I've
no LCAP configuration on my AE. My AE is UP/UP on the T640 and on the
CatOS. All it's fine, but I don't understand why, because in the Juniper
config Guide I found this : 
 
[...]
If the actor and partner are both in passive mode, they do not exchange
LACP packets, which results in the aggregated Ethernet links not coming
up.
By default, LACP is in passive mode on aggregated Ethernet interfaces
[...]
 
For me, in "ON" mode there is no LACP PDU transmited by the Switch and
my Juniper is in passive mode by default. Why the AE is coming UP ? LACP
is really in passive mode on the Juniper, or It's disable if I don't
configure "lacp passive" in my AE ?
 
The "show lacp interface" gives me only this : 
 
show lacp interfaces ae1
    Aggregated interface: ae1
 
Thanks,
Regards
 


*********************************
This message and any attachments (the "message") are confidential and intended solely for the addressees. 
Any unauthorised use or dissemination is prohibited.
Messages are susceptible to alteration. 
France Telecom Group shall not be liable for the message if altered, changed or falsified.
If you are not the intended addressee of this message, please cancel it immediately and inform the sender.
********************************