[j-nsp] Cable need to unplug/plug after box restarted

[Faizal Rachman]

i use external clocking.

show configuration interfaces e1-2/0/0
mtu 4500;
clocking external;
encapsulation cisco-hdlc;
unit 0 {
    family inet {
        address xx.xx.xx.xx/30;
    }
    family iso;
    family mpls;
}

On Fri, Apr 17, 2009 at 1:35 PM, Sean Clarke <sean at clarke-3.demon.nl> wrote:

>  On 4/17/09 8:15 AM, Faizal Rachman wrote:
>
> But if we ignore the restarted router, why should i have to unplug/plug E1
> cable facing to peer router to make it work again.
> I believe that keepalive  is kind of setting to make interface know while it
> is up or down. But after several times, link cannot revert back to normal
> until unplug/plug ritual.
>
>
>  That should not happen IMO ... there must be something else up .. timing
> ?
> However are you clocking the circuit ?
>