[j-nsp] Add vlan to multiple interfaces on EX series

[Dan Farrell]

I'm not sure that this is always a good idea, anyway.

Let's say you reach a point where you want to prune your interface membership... you just want, let's say, to remove one interface from the "range."

Would that action of deleting the line and re-submitting it without the interface you want remove reset the membership of the others? It's not unreasonable to think that action would take place.

IMHO in these instances I've always just dealt with it and added each one by hand, knowing I can prune any of the individually in the future with no possible effect on the remaining interfaces.

Also, the worst it's going to get would be 42 interfaces... 


Dan

-----Original Message-----
From: juniper-nsp-bounces at puck.nether.net [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Matt Stevens
Sent: Thursday, July 02, 2009 9:19 PM
To: Matt Stevens; juniper-nsp at puck.nether.net
Subject: Re: [j-nsp] Add vlan to multiple interfaces on EX series

Sigh...from everyone's answers it appears the short answer to this question
is no.

I guess I'll take this up with my account team.

Thanks everyone!
-- 
matt


On 7/2/09 12:25 PM, "Matt Stevens" <matt at elevate.org> wrote:

> Is there an easy way to add a new VLAN to multiple interfaces on the EX
> series switches? I'd like to be able to use a port range for both adding
> vlans to trunk ports and putting access ports into a specific vlan.
> 
> Both seem to only allow actions to be performed on a single port at a time.


_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp