[j-nsp] Add vlan to multiple interfaces on EX series

[Dan Farrell]

Sorry I meant to say 48 instead of 42 (typo), and that would encompass only a single chassis, not in a VC environment. 



Dan

-----Original Message-----
From: Shane Ronan [mailto:sronan at fattoc.com] 
Sent: Tuesday, July 07, 2009 9:59 AM
To: Dan Farrell
Cc: Matt Stevens; juniper-nsp at puck.nether.net
Subject: Re: [j-nsp] Add vlan to multiple interfaces on EX series

42 interfaces? How do you figure? With a virtual chassis  
configuration, you can have many more then 42 interfaces. I have one  
configuration where I have 192 ports in one configuration.


On Jul 3, 2009, at 4:12 PM, Dan Farrell wrote:

> I'm not sure that this is always a good idea, anyway.
>
> Let's say you reach a point where you want to prune your interface  
> membership... you just want, let's say, to remove one interface from  
> the "range."
>
> Would that action of deleting the line and re-submitting it without  
> the interface you want remove reset the membership of the others?  
> It's not unreasonable to think that action would take place.
>
> IMHO in these instances I've always just dealt with it and added  
> each one by hand, knowing I can prune any of the individually in the  
> future with no possible effect on the remaining interfaces.
>
> Also, the worst it's going to get would be 42 interfaces...
>
>
> Dan
>
> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net [mailto:juniper-nsp-bounces at puck.nether.net 
> ] On Behalf Of Matt Stevens
> Sent: Thursday, July 02, 2009 9:19 PM
> To: Matt Stevens; juniper-nsp at puck.nether.net
> Subject: Re: [j-nsp] Add vlan to multiple interfaces on EX series
>
> Sigh...from everyone's answers it appears the short answer to this  
> question
> is no.
>
> I guess I'll take this up with my account team.
>
> Thanks everyone!
> -- 
> matt
>
>
> On 7/2/09 12:25 PM, "Matt Stevens" <matt at elevate.org> wrote:
>
>> Is there an easy way to add a new VLAN to multiple interfaces on  
>> the EX
>> series switches? I'd like to be able to use a port range for both  
>> adding
>> vlans to trunk ports and putting access ports into a specific vlan.
>>
>> Both seem to only allow actions to be performed on a single port at  
>> a time.
>
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp