[j-nsp] BGP strange problem on M10i

[Felix Schueren]

Ramesh Karki wrote:
> Hello all,
> 
> We are facing some issues on Juniper M10i, i.e.
> 
> First, we had to hard reset the bgp peer whenever we change the policies
> (inbound policy) that we had set. By just doing soft reset the router will
> not take effect of that changed policies until we do hard reset. Sometimes
> even after hard reset, some strange issue were faced as for command:-
> 
> # sh bgp summary -
> 
> shows the peer is established but the line Active/Received/Accepted shows
> 0/0/0 respectively. However, we can view the received route on BGP table but
> it does not announce any prefixes towards that peer for return traffic. Last
> time when we had deactivated BGP, it wasn't updated-( BGP remained active).
> Only after rebooting the RE, the router operates as configured.
> 
> If anyone has faced similar issue, I would appreciated any sort of help in
> this regard.
> 
we had identical symptoms on an MX960 a couple months back. "restart
routing" was required. This was the first & last time we saw this. I
think we were on 9.3R2.8 back then.

Kind regards,

Felix

-- 
Felix Schüren
Head of Network

-----------------------------------------------------------------------
Host Europe GmbH - http://www.hosteurope.de
Welserstraße 14 - 51149 Köln - Germany
Telefon: 0800 467 8387 - Fax: +49 180 5 66 3233 (*)
HRB 28495 Amtsgericht Köln - USt-IdNr.: DE187370678
Geschäftsführer:
Uwe Braun - Alex Collins - Mark Joseph - Patrick Pulvermüller

(*) 0,14 EUR/Min. aus dem dt. Festnetz, Mobilfunkpreise ggf. abweichend