[j-nsp] L2circuit between Juniper and Cisco

[Ioan Branet]

Hello Alex,

I changed config and it works.

Thank you for your help!
John

On Wed, Feb 10, 2010 at 11:05 AM, Alexander Tarkhov <karabass at gmail.com>wrote:

> Hello John!
>
> On Juniper side this can be added to your logical unit configuration:
>
> unit 614 {
>    encapsulation vlan-ccc;
>    vlan-id 614;
>     input-vlan-map {
>        swap;
>        vlan-id 461;          # swap dot1.q tag before sending over network
>    }
>    output-vlan-map swap; # swaps to 614 before sending to local CE
> }
>
> Then check the output of show l2circuit connections summary
> It will give you a hint on any mismatch that can prevent the
> connection from being Up.
>
> Regards,
> Alex
>
>
> On Wed, Feb 10, 2010 at 11:03 AM, Ioan Branet <ioan.branet at gmail.com>
> wrote:
> > Hello group,
> >
> >
> >
> > I am traying to configrure a L2circuit between an MX and a 7600 as PEs
> > (ethernet-vlan mode).
> >
> > The problem is that the ping between CE1 and CE2 works only when I use
> the
> > same vlan-ids on both PEs.
> >
> > If I use different vlans ID , on Juniper side CE wont learn ARP .
> >
>
> [...snip....]
>
> > Any hint?
> >
> > Thank you,
> > John
>